3D-Printed Rear Seat Hinge Covers

For 1984–1989 Toyota 1st Gen 4Runner

Overview

These replica OEM rear seat hinge covers are designed to restore the factory finish of the rear seat area in 1984–1989 Toyota 1st Gen 4Runners equipped with original rear seat hinges. Over time, OEM hinge covers commonly crack, fade, or go missing, leaving exposed hardware and an unfinished interior appearance. This reproduction set provides a clean, durable replacement that preserves the original OEM look.

Material & Design Improvements

• Manufactured from high-strength ABS plastic

• Resistant to fading, brittleness, and discoloration

• Reinforced mounting clips to address the most common OEM failure point

• Designed to match original shape, contours, and mounting geometry

The reinforced clip design improves longevity while maintaining correct factory fitment.

Fit & Installation

• Direct-fit replacement for OEM rear seat hinge covers

• Installs using factory mounting points

• No trimming, drilling, or modifications required

Designed for straightforward installation during restoration, interior refresh, or rear seat service.

Manufacturing Details

• Proudly made in the USA

• Engineered for long-term durability in both restored and daily-driven vehicles

• Maintains OEM appearance and functionality

Important Fitment Note

Before purchasing, verify that your vehicle is equipped with OEM rear seat hinges.
OEM hinges can be identified by two distinct holes on the face of the hinge:

• One rectangular hole

• One combination circular/rectangular hole

⚠️ These covers will not fit aftermarket rear seat hinges that do not have these holes.